I. introduction to the machine
The main purpose of the slitting machine is to cut large drum roll into different width of the product, and can check the quality of the product. Its main features are as follows:
1. Coil photoelectric correction with high precision; Control mode is divided into two files: manual and automatic
2. There are two ways of winding: surface winding and center winding.
3. Automatic tension control is adopted for winding tension; The control methods include tension feedback control and taper control.
4. Round cutter shearing and air cutter cutting tools are reliable in quality and convenient in adjustment.
5. The center of the surface is adopted for rolling, and the quality of rolling is even and stable.
6. Automatic stop of fixed length and automatic meter counting of length;
7. Equipped with edge cutting device, the side material is discharged by the fan;
8. Suitable for cutting narrow band (insulation material, mica tape, film, etc.) of various thin type rolls
Ii. Scope of application:
1. Suitable substrate: mica tape, paper, insulating material and film cutting
2. Applicable industries: related industries with various insulation materials, special electrical paper and film
3. Applicable process: divided plate, finished product inspection, finished product roll, process material opening
Iii. Main technical parameters:
1. Machine speed (maximum) : 150m/min
4, put the biggest diameter of the roll material Φ 600 - Φ 1600
5, winding the grail: Φ 500 - Φ 1200
6. Minimum cutting width: 6mm
7. Cutting accuracy
8. Total power 10KW
9. Weight ~ 3500KG
The intelligence of the cutting machine is embodied in three aspects:
1. Process expert function intelligent
2. Intelligent operation expert function
3. After-sales service expert function.
The principle of
1. Paper cutting machine the entire volume or the whole of fixed length cutting and processing of raw materials, such as plastic packaging materials, packaging cartons, steel plates, film cutting and processing, leather, wood, etc, are used fixed length cutting control.
2. The cutting length can be set continuously. If the actual cutting length has error, it is easy to be calibrated by setting parameters.
3. The paper cutting machine can be divided into static and dynamic cutting control: stop the machine accurately when the set length arrives, then start the machine again after the static cutting. When the set length arrives, the cutting signal will be sent out without stopping. The cutting machine will conduct dynamic cutting in the process of material movement.
The central part of the paper tube cutter is equipped with the main shaft of the paper tube. The front end of the main shaft is fixed on the base with a set of bearings, and the belt wheel is installed in the middle of a set of bearings. A compression cylinder is installed near the base, and a set of support rod bearing is installed at the upper end of the support rod of the cylinder to support the spindle.
The upper end of the paper tube cutter is equipped with the spindle of the main knife, and several blades are arranged on it according to certain clearance. The support frame of the main tool shaft is also set at the top of the paper tube cutter, and a supporting cylinder is installed in the middle of the support frame.
The structural advantage of paper tube cutter fills the technical blank of automatic pipe cutter.
Related Industry Knowledge
- Introduction of automatic Cutting m...
- The basic function of lubricant for...
- Explanation of vibration isolation ...
- Specification for safety procedures...
- The structure knowledge of the tape...
- How to clean the labeling machine
- What factors directly affect the li...
- Technical requirements of operation...
- Off-ink phenomenon of self-adhesive...
- Label up
- Cutting machine introduction
- Cutting machine technical parameters