Home > News > Content
Check The Pipe Cutter Before Starting Up
- Jul 04, 2018 -

Check the pipe cutter before starting up


1. Check whether the saw blade is in good condition and should be replaced if there is any crack or crack.


2. According to the specification of high-pressure hose, replace the corresponding positioning pin shaft and guide sleeve.



Switch on the power and start the motor.


4. The high-pressure rubber tube will be cut into the replaced guide sleeve, and the trigger knife hand will push the rubber tube into the saw blade, then the rubber tube will be cut off.


5. Insert the inner hole of the cut rubber tube into the positioning pin shaft. When the saw blade rotates, cut a seam at the place where the rubber tube is ready to be stripped to ensure a good glue breaking effect.


6. Power must be cut off after work.