1.1 check whether the saw blade is in good condition and should be replaced if there is any crack or crack.
1.2 according to the specification of high-pressure hose, replace the corresponding positioning pin shaft and guide sleeve.
2. Operation steps
2.1 power on and start the motor.
2.2 the high-pressure rubber tube cut shall be put into the replaced guide sleeve, and the knife-shaped hand shall push the rubber tube into the saw blade, so that the rubber tube is cut off. When the skateboard is reset, it shall be pulled back to its original position by two tension springs.
2.3 insert the inner hole of the cut rubber tube into the positioning pin shaft. When the saw blade is rotating, a seam will be cut at the place where the rubber tube is ready to be stripped to ensure a good glue breaking effect.
2.4 after work, power must be cut off.
- What Is The Classification Of Ribbon
- What Problems Will Be Encountered I...
- Computer Slitting Machine Has Those...
- Registration Detection And Control
- Color Detection And Control
- Printing And Text Detection And Con...
- Packaging Of Environmental Protecti...
- Packaging Function
- The Highlight Of The Label
- The Blending Method Of Dark Ink
- Knitwear Classification
- World Cup Semi-finals
- Knitwear Washing
- Cutting Machines Operate
- Textile Maintenance
- Construction Of Excavator
- The 2018 World Cup Finals
- Classification Of Toilet Paper Rewi...
- Function Characteristics Of Rewindi...
- How To Remove The Paper Wool On The...