The rewinding of the slitter is the upper rewinding roller, the lower rewinding roller, the rear rewinding roller and the rewinding roller of the sequential device, and the slitter is rewound by pressing the roller in the base paper. During the process of lifting the base paper by the rewinding roller, the rewinding power supply of the slitter fails. What kind of treatment do we usually need?
The processing method of the rewinding power failure of the slitting machine is as follows:
1. When winding the product, the tension of the take-up shaft is too tight, or it is closely related to the glue when applying the glue;
2. If there are wrinkles on the semi-finished product during winding, the pressure of the tension cylinder can be appropriately increased.
3. When the center of the semi-finished product is loose, it is closely related to the unevenness of the glue and the unevenness of the substrate. At this time, the bow roller should be adjusted to make it flat, or the tension of the reel should be increased, and the substrate should be pressed tightly with the knife tube.
The slitter is a pre-press and post-press device used to cut large rolls of paper, film, non-woven fabric, aluminum foil, mica tape and other thin materials into small rolls of different widths. The slitting machine is characterized in that the electromagnetic powder clutch is used as a resistance device to control the resistance of the electromagnetic powder clutch.
In the case of a power failure during the rewinding of the slitter, the problem can be solved according to the above-mentioned treatment methods. The above mainly introduces the correct method to solve the power failure of the slitter.
